Cobalt Digital Inc 2000 Owner's Manual download pdf (Page 11)

9035 Owner’s Manual •

••

• (V 1.0.9) Page 11 of 27

Rear Module Installation (Optional)

If you are installing the card in a 8310-C-BNC or 8310-BNC frame (one with a 100 BNC rear module

installed across the entire back plane), skip this section.

If you are installing the card into a slot with no rear module, you should have ordered and received a

RM-9035-A Rear Module with your card. You will need to install it in your 8310 frame before you can

connect cables.

Use the following steps to install the RM-9035-A in an 8310 openGear

frame:

1. Refer to the openGear

8310 frame Owner’s Manual, to ensure that the frame is

properly installed according to instructions.

2. On the rear of the 8310, locate the card frame slot.

3. As shown in Figure 2, seat the bottom of the RM-9035-A in the seating slot at the

base of the frame’s back plane.

Figure 2. Rear Module Installation

4. Align the top hole of the RM-9035-A with the screw hole on the top edge of the 8310

back plane.

5. Using a Phillips driver and the supplied screw, fasten the RM-9035-A panel to the

8310 back plane. Do not over tighten.

This completes the procedure for installing the RM-9035-A in an 8310 openGear

frame.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 26 27

No comments

Cobalt Digital Inc 2000 Owner's Manual Page 11